The WSTIANMAO's electronic load burn-in chamber is applied in Shenzhen Busbar Sci-Tech Development Co., Ltd.

Since September 2014, WSTIANMAO began to cooperate with Shenzhen Busbar Sci-Tech Development Co., Ltd. (Ebusbar) and provided electronic load burn-in chamber for its product. Ebusbar is a service-oriented and high-tech enterprise specializing in R&D, manufacturing, marketing and sales of low carbon and high performance products which are widely used in renewable energy industry. Ebusbar covers mainly five production lines including bus bar, charging connector, charging terminal, high voltage connector and cell connector, which enable it to satisfy the global development of electric vehicle, solar energy, wind energy, smart grid, etc.

The core product of Ebusbar: Electric car charging terminal

The principles and purposes of this electronic load burn-in chamber:

In order to verify the charging circuit and PCBA life performance of electric car charging terminal, by adding electronic load in the form of the most realistic simulation, evaluate the performance of terminal in all aspects through the aging test experimental results. Due to the special design of its PCBA which cannot be applied by the most standard burn-in chamber in the market, WSTIANMAO developed a customized burn-in chamber to Ebusbar in order to satisfy its expectations.

1、The picture of burn-in chamber:

2、The picture of circuit control part inside burn-in chamber:

3、The picture of PCBA inside burn-in chamber:

4、This PCB board is used for electronic load aging test:

5、This is the operation panel of burn-in chamber: